Andrew. Allow me to break my "vow of silence", as it were, for a second, because you're taking some very aggressive shots at me, none of which are justified. When I first responded to your drawing, I had no idea that you had no idea how the mechanics of Gen 2 cases (which is what you have) worked, so I was reminding you...yes, with my "crude" drawing...that what you had drawn was physically impossible without A. popping another corner post, or B. (and infinitely less likely) warping and damaging the inner well and comic inside. Most people I know who spend $$$ on slabs have seen one or two cracked out, or have done it themselves, or at least watched a crackout video on the internet, to familiarize themselves with how the product they're putting so much trust in works. You don't need to crack a 4 or 5 figure slab to do that.
And now, you're angry...again...because you didn't understand what you were dealing with, and when someone gently corrected you, reminding you of the properties of the inner well (and not knowing you didn't know those properties)...with a picture, no less, which is about as non-confrontational as it gets...you immediately assumed bad faith, immediately assumed someone was "making a joke at your expense." But nothing could be further from the truth. I don't need to be "right" at the expense of others. No, I want everyone to be correct, so that everyone works from a position of knowledge.
I am a buyer AND seller of slabs. It is not only in my nature to want to be factually correct about the things that interest me, as a matter of personal pride, but it is in my business interests to make sure that misinformation about slabs doesn't proliferate. While everyone was praising your admittedly excellent drawing, they had missed the fact that there was a glaring error in it: the idea that a comic is not sealed into the inner well, and can simply be "tilted" and "pulled out" if one corner post is broken. That is not correct, for ANY generation of slab.
My goal wasn't to make you feel stupid. My goal was not to anger you. My goal was not to belittle you. My goal was not to "tweak" you. My meme about geometry was a very gentle poke about the physical impossibility of your drawing. My goal isn't...and I cannot emphasize this enough...to "shoo anyone away", but to make sure everyone goes into comics with KNOWLEDGE, because knowledge is power. People who know what they're doing are much, much less likely to be scammed, taken advantage of, or, as in your case, assume they're being taken advantage of when they're not.
My goal was to bring you to understanding, and prevent MISunderstanding in others who, like you, don't know the mechanics of these cases, how they're designed, and how they function, and might look at your drawing and internalize it, thinking what you drew is possible. It is not. It never has been. And it's important that that idea was corrected.
So, just so you know: for Gen 2 (which is what your slab was) slabs, the inner well is nearly the entire length and width of the case, and it is divided into two parts: the bottom part where the comic sits is completely sealed by a sonic weld on all four sides and cannot, outside of QC issues, be opened without cutting on the inside of that weld. The top part contains the label, and is lightly welded into the label on both sides, while the top is unsealed and open.
I get it. You're a very educated and talented man. You spent a lot of time and energy getting to where you are. And no one likes to be corrected, especially in public. But there are a lot of people who know a lot more than you AND me about many subjects here. And there's nothing wrong with that. Instead of assuming bad faith, perhaps just asking "what do you mean by that?" would smooth out the rough spots that may not actually even exist. Everyone has something they know that others don't, and learning is a lifelong process.
I hope my explanation brings clarity, if not reconciliation.
